HP LaserJet 1022: direct USB monochrome printing with manual duplex review

A USB printer for prepared monochrome work

The HP LaserJet 1022 fits a compatible computer producing modest monochrome documents through a direct USB connection. Its documented ordinary input is a 250-sheet tray plus a ten-sheet priority feed. The deciding limitation is attended handling: two-sided printing needs manual reloading, and the base model has no included Ethernet port or wireless radio.

HP's exact US product page identifies Q5912A#ABA and explicitly marks it discontinued. This is an earlier configuration assessment without a current-stock promise. HP's US specification gives a 110–127-volt, 60-Hz edition separately from a 220–240-volt, 50-Hz regional version. The original guides also warn that regional power sources are not interchangeable.

Establish the actual computer and driver

The original configuration and connection instructions give the base 1022 a USB 2.0 High Speed port. Connect the correct cable to the printer and then to the computer when prompted by compatible installation software. HP's current specification says the USB cable is purchased separately, so do not assume one accompanies an individual earlier unit.

The internal network port belongs to the 1022n and 1022nw, while the integrated wireless radio belongs to the nw. Accessory print servers or wireless adapters listed alongside the base model are optional. No adapter is added to this assessment's included configuration.

The original user guide describes host-based printer drivers. Historical operating-system lists and later HP support links are starting points for checking software, rather than a promise that an arbitrary current computer will work. Establish the actual compatible driver before relying on this old USB arrangement. AirPrint, Mopria and PIN-held job release remain unconfirmed.

The 1022 is a monochrome print-only machine. There is no scanner, flatbed, document feeder, copier or fax. A generic print-and-scan support application cannot supply missing document-capture hardware.

Ordinary paper and envelopes use different counts

The main tray holds 250 ordinary 20-lb/75-g/m² sheets. The original capacity table and current HP standard-input section positively identify a ten-sheet priority feed, giving 260 ordinary sheets combined. A loading paragraph also describes feeding one special-media sheet; that wording is not used to erase the separately documented ordinary stack.

The original service guide explicitly names Letter, Legal and A4 and describes both feeds for the supported media sizes. Load ordinary paper face up with the top toward the printer, set the guides to the actual size and straighten the entire stack when replenishing it.

One supported envelope uses the priority feed. For a batch, the original routine allows up to 15 envelopes in the main tray. Load the print face up, top along the left guide, with a short-edge flap entering first when present. Set the real envelope size and Envelope type in the compatible driver, adjust the guides and replace the input cover. Ordinary 260-sheet capacity is not an envelope count.

Two-sided printing requires the user at the printer

Choose Print on Both Sides (Manually), or Manual Duplex in the relevant historical Mac driver, and the appropriate binding option. After the first sides print, gather and straighten the pages. Reload them printed side down with the bottom edge entering first, replace the input cover and press Go for the reverse sides.

This is a driver-assisted two-pass routine. It does not satisfy an automatic-duplex requirement. HP declares up to 19 one-sided Letter pages per minute and separately 18 A4; these are maker ratings, not measured speed here or a promise about attended two-sided throughput.

The current maker recommended monthly range is 250–2,000 pages. The 8,000-page maximum duty and original 1,000-page average are separate figures. A requirement for 2,500 pages within the recommended range is therefore not satisfied merely because the maximum duty is larger.

Confirm supplies and allow operating room

HP's exact US compatibility list maps this model to 12A Q2612A. The current cartridge technical section declares approximately 2,000 pages based on ISO/IEC 19752, with actual yield varying by content and other factors. That replacement declaration does not promise the supplied or remaining toner in a particular discontinued printer, and no live cost per page is calculated.

The original unit body is 14.6 inches wide, 9.6 deep and 9.5 high. Allow extra paper support, cables, loading and cartridge access. Weight remains unconfirmed across cartridge-installed and later unspecified presentations. The 1022 works as a prepared direct-printing reference; essential independent sharing, scanning or unattended duplex calls for different documented hardware.